The 5 Most Common Problems of Garage Door Openers - By: Richard Palmer

Garage door opening without control: Make sure nothing is sitting on them and compressing them, if the controls are left in the car. Assuming it is not; check if the control is dirty and grungy. A button that is even slightly stuck can trigger the garage door. To clean around the edges try using rubbing alcohol and a cotton swab. Try to remember if you changed the batteries lately if your garage door starts opening by itself. If you did, then take try nudging the battery connectors after taking the battery out because they can move a bit and press against the pad in such a way that the garage door trigger is set off.

Garage door opener only opening part of the way: It is most likely a sign of wearing parts. The springs found on each side of the door can lose tension over time and eventually stops helping the opener with the maneuvering of the door. This can result in excessive weight to the opener and it can jam or mistake the weight as a indication the door is closed. The motor and gears are very puny and sometimes even made of plastic, so it will definitely wear out as the opener lugs the door up and down repeatedly year after year. Discard the gunk and grease the gear mechanisms. A good garage door specialist is always worth bringing in though you can fix it yourself.

Garage Door Opener Automatically Reverses: There are 2 sensors that are located on each side of the interior garage door frame. They send a signal to the motor unit, which will then refuse to close the door when something passes through them. The door moves some of the way and then reverses because it takes a few seconds to process this instance. Normally the area around the bottom of the garage door is dusty and dirty and removes anything that blocks them and the best solution is to lightly clean the lens of the sensors.

Garage Door Opener Motor Runs: There might be a problem with the opener itself or with the chain section. Disengage the garage door by pulling on the release cable halfway between the opener and the garage doors, making the door come down. Manually open or close the garage door to see if it still works. They are normally put under a lot of strain every time the door is closed or opened so click the opener to see if the gear assembly is broken. When the new gears may be so strong that they’ll immediately overwhelm the small motor and burn it out, you can have the opener system replaced or fixed. It is advised to just buy a new garage doors opener to prevent this problem.

When a Torsion Spring Snaps: A metal spring that has corroded would mean that the other springs are bound to break as well, and therefore need to be replaced. Immediately call a repairman to replace the springs. Always keep in mind that an ounce of prevention is worth a pound of cure. Rely on the services of a professional because you can never go wrong with them.

About the Author

Richard Palmer is a specialist in repairing and installing garage doors . His 10 years of experienced has developed his outstanding skill and knowledge. Visit http://www.usgaragedoors.com to get the best services on your garage doors.

Article Directory Source: http://www.articlerich.com/profile/Richard-Palmer/54609

Additional Articles From - Home | Home & family | Home improvement