How to Solve ' PHASE0_INITIALIZATION_FAILED' Windows Error? - By: jacob Luis

Windows NT architecture consists a range of services, which are collectively termed as Executive. This forms the low-level kernel-mode component and are comprised in NTOSKRNL.EXE file. At Windows startup, the initialization of Executive is one of the steps that is performed during Phase 4. This phase is further divided into two phases: Phase 0 and Phase 1. While phase 0 takes care of disabling the interrupts and initializing few Executive components, at Phase 1, the system is completely operational. However, if the process is interrupted, this causes a stop error message at Phase 4 of Windows startup sequence. The prime reasons for such behavior root from hardware issues. If not, you might need to reinstall Windows (as some of critical Windows components are damaged) provided a suitable backup is present. In case no valid backup is available, you need to use a Windows Data Recovery utility to extract the seemingly inaccessible data.

To illustrate such problems, consider an instance when you try to start a Windows-based computer. You might receive the below error message at Windows startup:

“PHASE0_INITIALIZATION_FAILED”

Or

“STOP: 0x00000031”

The error occurs at relatively smaller Phase 4 period of Windows startup.

Cause

The phase 0 of Executive initialization has failed. The possible reasons for this error to occur are as follows:

Faulty hardware
Recently installed or upgraded hardware
Recently replaced system files
Outdated firmware
Corrupted HAL or kernel files

Solution

To solve the above problem, you should try these methods:

You need to run the hardware diagnostics (included with the devices) on the system because most of the times, the issue is related to faulty hardware. The affected hardware should then be replaced.
You can restore the replaced system files, if any.
You should check that all the versions of peripheral firmware and motherboard firmware are recent.
If applying the above measures doesn't help, you should run the Windows Setup and reinstall Windows while making sure that a good backup is available. When you don't have a clean copy of your data, it is however, suggested that you use a powerful windows partition recovery application to retrieve lost data first. Windows Data Recovery utilities can scan and extract lost data even from a logically inaccessible drive.

Stellar Phoenix Windows Data Recovery Software is a powerful and efficient solution that recovers lost data from a Windows 7, Vista, XP, 2003, and 2000 installed system. The advanced Windows Partition Recovery tool provides advanced features like Raw File Recovery, Drive Status, Disk Cloning, and Disk Imaging. The software supports FAT32, VFAT, NTFS, and NTFS5 file systems.

About the Author

Jacob Luis is a student of Mass Communication and doing research on ntfs data recovery. He is also a undelete software specialist.

Article Directory Source: http://www.articlerich.com/profile/jacob-Luis/62163

Additional Articles From - Home | Computers | Data recovery