article directory
 

Garage Door Repair: Damaged Panel Replacement - By: Jim Sorenson NC

Now let’s say that the garage door is somehow damaged. It can happen to anyone. In a solid style garage door that, of course, means that a full replacement is required. However, in a sectional garage door, you may be able to get away with replacing only the damaged panel at substantial savings. Here are some tips for damaged panel replacement.

The Right Panel

For any number of reasons, both obvious and not, the damaged panel has to be replaced with the proper replacement piece. The best solution is to go to the manufacturer to find the right part.

Find out the manufacturer of your garage door. This should be listed on the door itself. You can usually find the replacement panel you need by going online to the manufacturer’s web site. If you are unable to find your parts this way, call a local overhead door manufacturer/installer. They should be able to find the parts. The individual panels will normally come in a replacement kit.

Use a tape measure to get the exact size of your replacement panel. All garage doors are not made equally or of a universal size.

Replacing the Panel

Once you have the correct panel replacement kit, you are ready to start.

Secure the garage door in place. Put the door in the down position and lock it there securely so it won’t roll up.
The door panels are held in place by hinged brackets, so you will need to disconnect them by unbolting the brackets using a hand or socket wrench. The panel of the door can then be slid out through the bottom of the track. The replacement panel can then slide back into place and be reattached to the door with a wrench.
If it is the bottom panel, only it will need to be removed. If it is a center or top panel, the panels below it will also need to be removed and then reset.

This replacement process can also be achieved by removing the entire door, but this will also mean that it will have to be re-hung and the spring tension of the system readjusted.

After Replacement

Check the mechanism and make certain that the door is properly functioning. Make certain the rollers are in alignment and all bolts properly tightened.

If you are still having problems, you may consider having a professional installer come in and finish the job. If the door tension needs to be adjusted, a professional may be the best solution to your problem as the tension of the spring makes it a dangerous process.

About the Author

Jim Sorenson is an expert in the field of garage door repair services and has been a professional in the garage door industry for over 10 years. Hopefully, his articles will help you understand your garage door better and perhaps assist you with Charlotte Garage Door Repair. He writes from his hometown of Charlotte located in North Carolina.

Article Directory Source: http://www.articlerich.com/profile/Jim-Sorenson-NC/224870




Click the XML Icon Above to Receive Articles Via RSS!

Page copy protected against web site content infringement by Copyscape

Do not copy content from the page unless you comply with our terms of service.
Plagiarism will be detected by Copyscape.