Anyone can Install A Fireplace Mantel in 6 Simple steps! - By: mattw1yyah

As you checked this article, I believed you're skilled enough to set up a mantel piece by yourself. If you're quite handy with tools, it is in reality quite easy. You can even save a great deal of money on the way.

When installing your mantel, two key components are crucial: a) observing the right distance from the mantel from the fire and b) ensuring the mantel is securely connected to the wall.

Let's assume that you have the best mantel piece of your decision, listed here are 5 simple steps to help you. Make absolutely certain you follow each correctly.

You'll need the following:

• Tape Measure

• Spirit Level

• Drill

• Masonry drill bit

• Screwdriver

• Circular saw

• Screws

• Wood Putty

The first step - Dry fit the Fireplace Mantel

Place your mantel piece contrary to the fireplace, exactly inside the spot in which you want to buy positioned. Make an effort to center it on the opening or firebox. You have to leave some clearance with a minimum of 6 inches for safety measures. With the spirit level, look at the level. You need to make sure that the shelf is level from front to the height of the mantel. You may need to put wooden shims under both legs until both levels are balanced.

Step two - Mark the career

Now, mark the positioning of the fireplace mantel by tracing its outline using a pencil even though it is still up against the wall. You may need to do the outlining repeatedly just to be sure. It is then simpler for you to look for the keeping your wooden support called cleats down the road.

Step 3 - The Cleats

When the marking is fully gone, consider the mantel piece down and lay it top-down on to the floor. You now need to look at the width with your shelf as well as the length in the supporting legs to understand along the horizontal and also the vertical cleats. Using the circular saw, cut 2X4-inch-by-8-foot pieces of lumber to make your cleats. Dry fit them inside to ensure a snug fit.

Step 4 - Drilling the Pilot Holes

Before drilling, measure first the width of the mantel edges that may sit flush from the wall. Then inside the pencil scribe of the mantel's outline, mark the length in which you wish to hang the cleats. With all the spirit level, connect the dots.

While holding the cleats in position, use the hammer to bore evenly spaced five holes with the cleat boards and to the brick. Switching towards the screwdriver drill bit, screw inside the screws into the pre-drilled cleat boards and fireplace bricks. Do the identical process for the remaining cleat legs.

Step five - Installing the Mantel

Install the mantel piece about the wall. Make sure that you line it with all the fireplace round the support cleats. Use the hammer and screwdriver to screw inside the finishing screws at the top with the mantel piece in to the cleat. Countersink them slightly to hide them from view. Repeat the identical process with each one of the mantel legs.
Step six - Finishing Touches

To disguise the holes left through the screws, fill them along with wood putty or decorative plugs that match your mantel piece. This may give your mantel piece the professional look.

You can further customize your fireplace mantel by placing family portraits along with other accents on its shelf. Or better yet, beautify your hearth by buying functional and decorative fireplace accessories for an even charming and enjoyable fireplace experience.

About the Author

To find the best Fireplace Mantels and Fireplace Accessories click here to find out.

Article Directory Source: http://www.articlerich.com/profile/mattw1yyah/169233

Additional Articles From - Home | Home & family | Home improvement