article directory

Anyone can Install A Fireplace Mantel in 6 Simple actions! - By: mbrengcfet

Because you checked this information, I believed you're skilled enough to setup a mantel piece by yourself. In case you are quite handy with tools, it really is not hard. You can also save a great deal of money as you go along.

When installing your mantel, two important components are necessary: a) observing the right distance with the mantel through the fire and b) making certain the mantel is securely connected to the wall.

Let's assume that you currently have the best mantel bit of your selection, listed below are 5 simple steps to help you. Just be sure you follow each correctly.

You'll need these:

• Tape Measure

• Spirit Level

• Drill

• Masonry drill bit

• Screwdriver

• Circular saw

• Screws

• Wood Putty

1 - Dry fit the Fireplace Mantel

Place your mantel piece up against the fireplace, exactly in the spot in places you want it positioned. Attempt to center it around the opening or firebox. You need to leave some clearance of at least 6 inches for health concerns. While using spirit level, look at the level. You'll want to ensure that the shelf is level from front to the height from the mantel. You might need to put wooden shims under each leg until both levels are balanced.

Step # 2 - Mark the job

Now, mark the position of the fireplace mantel by tracing its outline having a pencil though it may be still facing the wall. You may need to do the outlining repeatedly just to be certain. This makes it simpler for you to determine the placement of your wooden support called cleats afterwards.

Step # 3 - The Cleats

Once the marking is fully gone, make mantel piece down and lay it top-down on the floor. The next step is to measure the width within your shelf along with the length in the supporting legs to learn the size of the horizontal as well as the vertical cleats. With all the circular saw, cut 2X4-inch-by-8-foot items of lumber to produce your cleats. Dry fit them inside to ensure a snug fit.

Step # 4 - Drilling the Pilot Holes

Before drilling, measure first the width of the mantel edges which will sit flush contrary to the wall. Then in the pencil scribe of the mantel's outline, mark the length that you need to hang the cleats. Using the spirit level, connect the dots.

While holding the cleats in position, utilize hammer to bore evenly spaced five holes from the cleat boards and into the brick. Switching for the screwdriver drill bit, screw inside screws into the pre-drilled cleat boards and fireplace bricks. Do a similar process to the remaining cleat legs.

Step # 5 - Installing the Mantel

Install the mantel piece for the wall. Make sure that you line it with all the fireplace across the support cleats. Utilize the hammer and screwdriver to screw in the finishing screws at the top from the mantel piece into the cleat. Countersink them slightly to cover up them from view. Repeat the same process with each one of the mantel legs.

Step 6 - Finishing Touches

To disguise the holes left by the screws, fill them together with wood putty or decorative plugs that suit your mantel piece. This can give your mantel piece the professional look.

You can further customize your fireplace mantel by placing family portraits along with other accents on its shelf. Or also, liven up your hearth by purchasing functional and decorative fireplace accessories on an even charming and enjoyable fireplace experience

About the Author

With help about installing your Fireplace Mantels and Fireplace Mantel Shelves click here.

Article Directory Source: http://www.articlerich.com/profile/mbrengcfet/176838




Click the XML Icon Above to Receive Articles Via RSS!

Page copy protected against web site content infringement by Copyscape

Do not copy content from the page unless you comply with our terms of service.
Plagiarism will be detected by Copyscape.